Kambrook KRH110 - Manual (Page 9)

8
Using Your Kambrook Radiant Heater
Before first use
Remove your heater from its carton
and associated protective wrapping.
Unwind the cord to its full length and
remove any protective cardboard
or foam that may have been used
to minimise transportation damage.
Place the heater on a firm, level
surface in a stable upright position.
Visually inspect the air inlet and
outlets to ensure no foreign material is
blocking these areas.
Turning Your Heater On
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into the
same circuit with your heater when
you switch the unit on.
1. Your heater must be wall
mounted and no closer that
25cm to ceiling, 200cm to floor,
25cm to side walls.
2. Remove the mounting bracket
from the rear of the heater and
secure to the wall with the five
screws supplied. To wall mount
correctly, ensure the bracket
is placed on the wall so that
the keyhole slots have two on
top, and one on the bottom
(See Fig.1).
Fig. 1
NOTE: Fixed wire installations
should be performed by a
qualified electrician.
3. Hook heater base onto mounting
bracket on wall aligning the
heater base clips on the mounting
bracket and slide downwards to
fit in position (See Fig.2).
Fig. 2
4. Plug the power cord into a 230V
or 240V electrical outlet. Be sure
the plug fits tightly as a loose
fit will cause overheating and
damage the plug.
5. To switch the heater on, pull the
Power On/Off cord until it clicks
and the neon light illuminates.
6. To switch heater off, pull the
Power On/Off cord again
until it clicks and the neon
light goes out.