Kodak i250 - Manual (Page 41)

C-2 A-61167 September 2002
Installing the Imprinter
Removing the
Circuit Board Cover 1. Make sure that the scanner is powered down and there are no documents
in the feeder area.
2. Disconnect the power cord from the back of the scanner.
3. Disconnect the IEEE-1394 (FireWire) cable from the IEEE-1394 port on
the back of the scanner.
4. Lift up the scanner door release to unlatch the scanner door.
5. Pull up to open the scanner door.
6. Remove the output tray.
7. Lift up the scanner door release again and open the scanner door past the
circuit board cover.
8. Use a Phillips-head screwdriver to remove the two screws (one front, one
back) that hold the circuit board cover in place.
Circuit board cover