Kenwood KDC-115S - Manual (Page 14)

English
— 14 —
Connecting Wires to Terminals
P.CONT.OUT
ANT.
CONT.
–
+
–
+
–
+
–
+ FRONT • L
FRONT • R
REAR • L
REAR • R
– +
FUSE 10A
L
R
REAR
When only two speakers are being connected to the system,
connect the connectors either to both the front output
terminals or to both the rear output terminals (do not mix
front and rear). For example, if you connect the + connector
of the left speaker to a front output terminal, do not connect
the - connector to a rear output terminal.
2CAUTION
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those wires
to the power source running through the fuse box.
2WARNING
FM/AM antenna input
Rear left output (White)
Rear right output (Red)
Fuse (10A)
Wiring harness
(Accessory1)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left
speaker
To front right
speaker
To rear right
speaker
To rear left
speaker
Power control/Motor antenna
control wire (Blue/White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
Ignition key
switch
Car fuse box
(Main fuse)
ACC
Car fuse
box
Battery
If no connections are made, do not let the wire come out from the tab.
Connect either to the power control terminal
when using the optional power amplifier, or to
the antenna control terminal in the vehicle.
KDC-115S_U.S 00.12.26 3:40 PM Page 14