Registering in a dect base station – Konftel 200w User Manual
Page 5
Key/LED
Reg
Base 1
0-9...
PIN:
****
Done
Search
PARK:
DECT system:
You need to register your Konftel 200W in a DECT base station before it can be used. Here we
explain how to register in a
Konftel DECT base station. To register your Konftel 200W in other
makes of base station, simply follow the same procedure. Please refer to your base station
instruction manual or contact your company’s switchboard administrator if you are unsure.
Set Konftel DECT base station in registration mode
Press and hold the key/LED on the base station until it starts
to flash.
The base station is now in registration mode. Once registration
has been completed, the LED will stop flashing. If the base
station does not identify a DECT phone within 2 minutes, the
registration mode will switch off automatically.
Register Konftel 200W in a DECT base station
Press the
MEnU key.
Select the menu tool using the
Up/down key.
Press
oK.
Select the menu
Reg using the Up/down key.
Press
oK.
Select a base (1–4).
If no base station has been programmed, choose no. 1. Numbers
that are ticked are being used.
Press
oK.
Select a DECT system.
Press
oK.
Enter the security code (PIN code) (standard code is
0000).
Press
oK.
Some DECT systems (not Konftel DECT Base Station) require a
PARK code. Check with your company’s switchboard supplier.
Enter the PARK code if this is required. Otherwise, leave blank.
Press
oK.
Your Konftel 200W is now in registration mode and is searching
for a base station in registration mode. Wait until you receive
confirmation that registration has been completed. Registration
can be interrupted by pressing
C. If registration was successful,
the word
Done will appear in the display.
Press
oK.
The Konftel 200W is now ready to use.
REgiSTERing in A DECT bASE STATion