Kambrook KRH500 - Manual (Page 3)

IMPORTANT PRECAUTIONS
When using electrical appliances,
basic precautions should always be
followed, including the following:
1. Keep combustible materials such as
drapes and other furnishing away from
heater.
2.The heater must NOT be located
immediately below a socket outlet.
3. Extreme caution is necessary when this
heater is used by or near children or
invalids.
4.Young children should be supervised to
ensure they do not play with the heater.
5. Important – this heater is intended for
floor use only. Do not mount on ceiling or
walls.
6. Do not leave heater unattended. Always
switch off the heater at the controls and
at the power outlet then unplug heater
from the power outlet when not in use.
7. Do not operate any heater with a
damaged cord or plug, or if heater has
been dropped or damaged in any manner.
Return heater to your nearest service
centre for examination, electrical or
mechanical adjustment or repair.
8. Do not use outdoors.This heater is not
intended for commercial use such as
construction sites.
9.This heater is not intended for use in
wet or moist locations such as bathrooms
or laundry areas. Do not immerse or
allow liquids to be spilt on heater.
10. Place unit well clear of heat sensitive
surfaces and where necessary place on a
suitable stable inflammable surface.
11. Do not run the cord under carpeting
or cover the cord with rugs, runners or
the like. Arrange cord away from traffic
areas and where it will not be tripped over.
12.To prevent a possible fire, allow ample
space around the heater (at least 1.7m at
front and 0.5m at the rear, top and sides)
and do not block air inlets or outlets in
any manner. Check the openings from
time to time for accumulated dust. Ensure
long shag carpet does not obstruct air
flow under unit
13.To disconnect heater switch the
control setting to the OFF position, then
switch off at the power outlet prior to
removing the plug from its outlet.
14. Do not insert or allow foreign objects
to pass through the element guard as this
may cause an electric shock, fire or
damage the heater.
15. Do not touch hot metal surfaces.
16. Do not allow power cord to contact
hot metal surfaces. Do not operate heater
with the cord hanked or wound around
any part of the heater
17. Set the control setting to the OFF
position then Unplug and allow heater to
cool down before cleaning or storing.
18. Do not use the heater with a
programmer, timer or any other device
that switches the heater on automatically,
since a fire risk exists if the heater is
covered or positioned incorrectly.
3