Knoll OUT650 - Manual (Page 2)

support could be a fishing leader attached to the U
bracket and wall.
Connect the speaker wires to the gold binding posts.
Polarity is very important as wrong polarity will give
lousy sound quality and especially poor bass.
Secure the speaker to the U bracket with the
threaded knobs. Aim the speakers to the correct
angle, then hand-tighten the knobs.
NEVER use pliers or power tools to tighten the knobs.
Speaker Specifications
OUT650
Speaker Design: Indoor/outdoor bass reflex ABS plastic
speaker system, weather resistant design.
Tweeter: 1"(25mm) silk dome, with neodymium
magnet and wave guide.
Woofer:
6-1/2"(165mm) kevlar cone with butyl
rubber surround.
Frequency Response: 50Hz to 20kHz ± 3dB
Impedance: 8Ω
Power Handling: 5 to 120 watts
Efficiency:
90dB @ 1W/m
Grills: Powder coated aluminum
Dimensions: 12" H, 8 ½" W, 7 ¾" D
Weight (each): 7.95 lbs (3.6 kg)
Speaker Warranty
Knoll Systems warrants its speakers sold in the USA and
Canada by authorized Knoll dealers to be free of defects in
materials and workmanship. This warranty extends for five
full years from the date of purchase by the original consumer.
Any products returned to Knoll Systems and found to be
defective by Knoll Systems within the warranty period will be
repaired or replaced at Knoll Systems option, at no charge.
Knoll Systems will not be responsible for the actual cost of
installation or removal of the product, nor for any incidental
or consequential damages. Some states do not allow the
exclusion or limitation of incidental or consequential damages,
so the above limitation may not apply to you. This warranty
gives you specific legal rights. You may have additional legal
rights that vary from state-to-state.
Mounting using aftermarket brackets
More precise aiming of the OUT650 can be
accomplished by using ball joint and other aftermarket
mount systems. Dual ¼”- 20 brass inserts are fitted
into the OUT650 for aftermarket brackets.
¼” – 20 brass
fittings for
aftermarket
brackets
gold 5-way
binding post
plates
Technical Assistance and Service
The Technical Assistance Department at Knoll is available at
604 272-4555 to answer any questions concerning the
operation and installation of your speakers, between the
hours of 9 a.m. and 5 p.m. Pacific time, Monday through
Friday, except holidays.
In the event that your unit should need repair or service you
may return the unit to your authorized dealer or use the
following guidelines:
1) Be prepared to state the model number and or serial
number, date of purchase and dealers name and address when
calling.
2) Contact Knoll directly at 604 272-4555 for a return
authorization number (YOU
MUST HAVE PRIOR
AUTHORIZATION TO RETURN YOUR UNIT).
4) The original packaging must be used. If the original
packaging is not available, replacements can be obtained from
Knoll for a small fee or you can use other packaging so long as
product damage from shipping will not occur.
5) Ship the product via United Parcel Service, Federal
Express.
6) Print the return authorization number on the outside of
the box.
7) Ship to:
Attn: Technical Assistance Department
Knoll Systems
145 Tyee Drive
Point Roberts WA 98281
Or
Knoll Systems
11791 Machrina Way, #110
Richmond BC Canada V7A 4V3
8) FREIGHT COLLECT SHIPMENTS WILL BE REFUSED! You
are
responsible for the freight charges when returning
product. If the unit is found to have a warranty problem we
will pay the return freight charges.