Kompernass KH 5540 - Manual (Page 5)

- 3 -
Technical Data
Mains adapter
Input voltage:
100 - 240 V ~
50/60Hz
Output Voltage: 4.5 V 1000 mA
Men‘s Shaver
Input voltage:
4,5 V 1000 mA
Protection class: IPX4
Shaving without the power cable
This Men‘s Shaver can be used without the power
cable. In this case, the appliance must be charged
up before the first usage.
1. Insert the connector plug q into the socket 7
on the Men‘s Shaver. Pay heed to the correct po-
larity: The guide pillar in the socket 7 must grip
the guide rail on the connector plug q. If it does
not, the connector plug q cannot be inserted.
2. Connect the plug with a mains power socket.
The battery will be charged. The battery charge
indicator 6 blinks. The more lamps in the battery
charge indicator 6 there are that glow permanently,
the higher the current charge is. When the appliance
is completely charged (all lamps on the battery charge
indicator 6 glow), remove the mains power adap-
ter 0 from the socket 7 and separate it from the
mains power supply. The Men‘s Shaver can now be
used without the power cable.
Note:
Should the batteries be completely discharged, the
recharging process requires approx. 90 minutes. Af-
ter recharging you can use the Men‘s Shaver for
approx 60 minutes.
+ –
Note:
Do not recharge the battery after every use. Only
recharge the battery when the lowest lamp on the
battery charge indicator 6 blinks. This will optimise
the performance of the battery.
Shaving using the power adapter
Should you wish to use the Men‘s Shaver without first
charging the battery, you can do so by using energy
directly from the mains power adapter 0:
1. Insert the connector plug q into the socket 7
on the Men‘s Shaver. Pay heed to the correct po-
larity: The guide pillar in the socket 7 must grip
the guide rail on the connector plug q. If it does
not, the connector plug q cannot be inserted.
2. Connect the plug with a mains power socket.
Wait for 3 - 5 minutes.
The Men‘s Shaver can then be used.
Intended purpose
Shaving
Note:
The best shave is achieved with dry skin.
1. Remove the protective cap r.
2. Press the locking switch 4 and, at the same
time, slide the On/Off switch 5 upwards.
The cutting heads rotate.
3. Guide the cutting heads 1 with straight and
circular movements over the skin.
Note:
In the first 2 to 3 weeks you could suffer some light
skin irritation, until your skin has got used to the
cutting heads. Should the skin irritation continue
beyond this time, consult your doctor.
IB_KH5540_32925_LB6 05.06.2009 12:19 Uhr Seite 3