Troubleshooting – Karcher G 2500 OH User Manual

Page 12

Advertising
background image

12

Please remove the spark plug cable to

prevent accidental ignition of the engine

before making any repair.

Engine will not start.

• No gasoline.

- Fill gas tank.

• Choke is not in correct position.

- Slide choke lever out to closed

position.

• Engine throttle is not in correct

position.

- Slide the throttle lever up about 1/3 of

the way toward the fast position.

• Pressure built up in the high pressure

washer.

- Squeeze the trigger to release the

pressure.

For additional engine problems refer
to the engine owners manual.

Unit does not reach high pressure.

• Diameter of garden hose is too small.

- Replace with a 3/4 inch garden hose.

• Water supply is restricted.

- Check garden hose for kinks, leaks

and blockage.

• Not enough inlet water supply.

- Open water source full force.

• Water inlet filter is clogged.

- Remove filter and rinse out in warm

water.

• Black detergent nozzle is attached.

- Remove black detergent nozzle and

attach a high pressure nozzle.

Output pressure varies high and low.

• Not enough inlet water supply.

- Turn water on full force. Check garden

hose for kinks, leaks or blockage.

• Pump is sucking air.

- Check that hoses and fittings are air

tight. Turn off machine and purge
pump by squeezing trigger gun until a
steady flow of water emerges through
the nozzle.

• Water inlet filter is clogged.

- Remove filter and rinse out in warm

water.

• Spray nozzle is obstructed.

- Blow out or remove debris with a fine

needle.

• Calcified gun, hose or spray wand.

- Run distilled vinegar through deter-

gent suction tube.

No detergent.

• Detergent suction tube not properly

connected to the machine.

- Check connection.

• Detergent is too thick.

- Dilute detergent. For best results, use

Kärcher detergent.

• Detergent filter valve is at lowest

setting.

- Set detergent filter valve to a higher

setting.

• Filter on detergent suction tube is

clogged.

- Run warm water through filter to

remove debris.

• Damaged or clogged detergent

suction tube.

- Remove obstruction or replace

detergent suction tube.

• A high pressure nozzle is attached.

- Replace with black detergent nozzle.

• Spray nozzle is obstructed.

- Blow out or remove debris with fine

needle.

TROUBLESHOOTING

Advertising