Kenwood MDX-G2 - Manual (Page 48)

48 EN
7 Execution
6
Press the ON/STANDBY key
(or POWER key on the remote
control) to put the unit in the
STANDBY mode.
The STANDBY/TIMER indicator lights
in green.
When the set ON time comes, the
timer program is executed and record-
ing starts.
To cancel program timer :
Perform steps 2 to 4 and select “TIMER
OFF” of “Program timer” (page 45) until
“PROG.” is not lit.
To check or change the timer setting :
Restart the procedure from step
1 again.
÷ Be sure to adjust the time of the day (page
7) before using the timer functions.
÷ The speakers’ output will decrease during
timer recording.
÷ Even when the program timer is canceled,
previously made setting is stored in memory
and remains until new timer information is
set the next time.
÷ When the STANDBY/TIMER indicator is blink-
ing in green, the timer setting or clock set-
ting is erroneous. Check and correct them
as required (pages 7 & 47 to 48).
4
Press the VOLUME/MULTI CON-
TROL keys to select “TUNER” or
“AUX”, then press the SET/TUN-
ING MODE key.
“TUNER”: Radio
“AUX” : AUX input source
5
To record a radio station, press
the VOLUME/MULTI CONTROL
keys to select preset station to
be recorded, then press the SET/
TUNING MODE key.
*5052/43-49/EN 5/29/01, 10:40 AM 48