Keyspan Alexadria DuraWand Portable Scanner - Manual (Page 3)

2
Replacing the Durawand Batteries
REQUIRED ITEMS FOR BATTERY REPLACEMENT:
Allen wrench to remove DuraWand end cap screw
Four AAA nickel-cadmium batteries
The following steps will guide you through replacing your DuraWand batteries:
1. Transfer your data from your DuraWand using the Videx Downloader application.
2. To replace the batteries, remove the end cap of the DuraWand by removing the end cap screw. The
key ring will come loose when you remove the screw. Place the key ring, washer and end cap screw
in a safe place to prevent loss.
3. Remove the four old batteries and replace with four fresh AAA nickel-cadmium batteries. Be sure
the batteries are installed correctly.
4. Insert the key ring into the small slot on the end cap.
Reinstall the end cap onto the DuraWand. You will need
to exert pressure to the end cap to get it to fit snugly.
Insert the washer and end cap screw and tighten the end
cap screw. The washer holds the key ring in place, and
the end cap screw holds the washer, key ring, and end
cap in place.
Remember to transfer the data from DuraWand using the Videx
Downloader application before replacing batteries. DuraWand data
will be erased when the end cap and batteries are removed.