Kenwood D-R350 - Manual (Page 18)

D-R350 (En)
18
Repeated playback
To repeat only the programmed tracks
Preparation ÷ Load a disc in the CD player.
÷ Set the INPUT SELECTOR to ”CD“ on the
connected device such as AV CONTROL
CENTER or receiver.
Repeat
Return
ENTER
ENTER
To cancel repeated playback
Press the REPEAT key twice. (REPEAT ON
→
OFF)
(
E R E P T A O N
7
Start playback.
The current status is displayed when the key is pressed
once. When it is pressed while the status is displayed, the
repeat ON status can be set to OFF (or vice versa).
GRC operation RC operation
1
Press so that the “PGM” indicator lights.
PGM
Mode
P.mode
ENTER
ENTER
ENTER
Go to step
4
within 8 seconds.
P.mode
ENTER
5
Repeat steps
2
–
4
above.
4
Set the entry.
6
Switch REPEAT ON.
2
Select the disk.
Go to step
3
within 8 seconds.
3
Select the desired track No.
1 2 3
4 5 6
7 8 9
0 +10
ENTER
+10
5 4 3 2 1
0 9 8 7 6
: Keys and control used in the operations described on this page.
Disc Skip
ENTER
P.MODE
REPEAT
DISC SKIP
P.MODE
6
PGM
ENTER
ENTER
÷ All of the programmed tracks will be repeated.
÷ In case only one track is programmed, only that track will be repeated.
÷ Up to 32 tracks can be programmed. When “
FULL ” is displayed, no
more tracks can be programmed.
G P 0 M 1 I D C S ?
GRC operation : Complete the procedure in “Basic Operations
for the Graphical Remote Control Unit (GRC)”
90
REPEAT
Main unit operation
To display the current status, first select the Return icon and press
the ENTER key, and then select the Repeat icon and press the
ENTER key.
Pressing the
ENTER key again while the status is displayed will set
the repeat ON status to OFF (or vice versa).
GRC operation