Kompernass KH 2262 - Manual (Page 6)

6
4. Operation
This section applies when the device has
been connected as described in chapter 3:
4.1 Switching the device on/off
൶ The device is equipped with a
FUNCTION sliding switch for all three
modes:
The device is switched on and is consu
ming electricity when the switch is
switched to …
• "Radio" for radio mode
• "CD" for CD mode.
The device is switched off when the
switch is switched to position ...
• "TAPE/POWER OFF". This also the
position for tape mode. In this position,
the device consumes near to no
electricity, as long as none of the tape
operating keys are pressed.
4.2 Adjusting the volume
൵ Turn the volume control clockwise (lou-
der) - or anti clockwise (quieter).
4.3 Bass-booster function
൸ Press the BASS BOOST switch to
activate or deactivate the Bass booster
function.
5. Radio mode
Select "Radio" on the FUNCTION sliding
switch.
5.1 Channel search
൹ Chose a reception bandwidth. By pres-
sing the button BAND you can switch
between ...
• "FM" for VHF reception or
• "MW(AM)" for medium wave
reception.
To search the bandwidth press the
button ...
඀ TUNINGį , to search forwards or
඀ TUNINGĬ , to search backwards over
the entire reception range.
If you apply pressure to the buttons lon-
ger than a second the device will start an
automatic channel search. As soon as a
channel with sufficient reception quality has
been found, the automatic search stops
immediately.
Tip: When in VHF reception (FM) mode,
you will achieve better reception quality by
putting the antenna into at an angle. Then
turn the antenna until the best reception is
found.
For medium wave (AM) reception, the
device uses the internal antenna. Turn the
entire appliance until you achieve the best
reception result.
5.2 Mono/Stereo
When a program is broadcast on the VHF
range in stereo, "ST", is displayed on the
device, while "MONO" appears for Mono bro-
adcasts. Should the stereo reception crack-
le due to bad reception …
ൽ press the ST/MONO button to switch
between the two modes.
5.3 Storing channels
You can store a total of 15 channels. When
you have found a channel you would like to
store ...
ൿ press MEMORY .The display shows the
number of the first memory position, and
the"MEMORY" indicator flashes.
ർ You can now browse through the
memory positions by pressing the M-UP
button.
KH2262_LB4_UK_Ka 13.11.2003 14:04 Uhr Seite 7