Kodak A-61195 - Manual (Page 14)

A-61195 July 2003 9
SCSI interface
device ID
When there are several devices on a SCSI chain, you may need to adjust the
SCSI ID selector on the scanner. This selector assigns a specific device ID
to the scanner. If the assignment conflicts with an existing SCSI device, select
a new ID.
NOTE: The factory SCSI ID setting for the scanner is 6. SCSI ID 0 is usually
assigned to an internal hard disk drive and 7, 8, and 9 are not in
actual use. The scanner will not operate properly if the SCSI ID is
set to 7, 8, or 9.
• Using a suitable tool, turn the SCSI ID selector switch until the arrow points
to the desired ID number.
Setting the
SCSI terminator The scanner comes with a built-in SCSI terminator. The terminator ON/OFF
switch is located on the scanner between the SCSI cable connectors.
• If the scanner is the only or the last device in a SCSI chain, place the
terminator switch in the ON position.
• If the scanner is to be located between the computer and another SCSI
device, place the terminator switch in the OFF position.
SCSI ID selector
SCSI terminator switch