KITCHENAID KERH507 - Manual (Page 14)

14
U
sing a nd C aring f or Y our C ooktop
Using and replacing the cooktop light
The fluorescent light is on the top of the
control panel. The cooktop light switch is on
the control panel. Press it to turn on the
cooktop light. Press it again to turn light off.
Replacing the cooktop light:
1. Unplug appliance or disconnect at main
power supply.
2. Flip up the top of the control panel.
REAR
OFF
H I
L O
MED
M E D H I
M E D
L
O
• MAXI •• ECONO BAKE
BROIL BROIL CLEAN
BAKE BROIL BROIL ROAST ROAST
AUTO SET
TEMP TEMP PROBE PROBE
CONVECTION CONVECTION
START
TIME TIME
CLOCK CLOCK SET STOP STOP
TIME TIME
OVEN OVEN LIGHT LIGHT DELAY/TIMED DELAY/TIMED
DELAY
CLEAN
DEHYD
TIMED
LOCKED
ROTIS
START?
M
START STOP MIN HR
CLEAN
ON
2
OFF 4
• MAXI • MAXI •• ECONO •• ECONO BAKE
BROIL CLEAN
BAKE BROIL ROAST
AUTO SET
TEMP PROBE
CONVECTION
START TIME
CLOCK SET STOP
TIME
OVEN LIGHT DELAY/TIMED
DELAY
CLEAN
DEHYD
TIMED TIMED
LOCKED
ROTIS
START?
MIN MIN
START STOP MIN MIN HR
CLEAN
ON
REAR
OFF
H I
L O
MED
M E D H I
M E D
L
O
3. Grasp the fluorescent tube at both ends.
Turn the tube approximately 90° in either
direction until both ends come out of the
receptacles. Replace with a 20-watt cool-
white fluorescent tube.
If the cooktop light still does not work,
you may need to replace the starter. The
starter is a knob-shaped part located on
the right side of the backguard, under the
light bulb. To remove and replace the
starter, first remove light bulb. Push
starter in and turn approximately 90°
counterclockwise. Pull starter out of
recessed area. You can find replacement
starters at stores that sell fluorescent
tubes.
4. Close the top panel. Plug in appliance or
reconnect at main power supply.