KVH Industries KVHTRACVISION G4 - Manual (Page 143)

Startup Data Sequences
54-0147 143
Appendix F
Startup Data Sequences
The data on the following pages presents a sample startup
data sequence registered by the TracVision G4. These sequences
may vary based on the software version loaded onto the
TracVision G4 system. This data can be recorded using the data
port and a PC.
TracVision G4 Controller Rev X - Version X.XX - Serial number XXXXXXXX
EAD Motors
RF: CHECKSUM
RF: ZAP
RF: ?PGM_908
RF: CHECKSUM: 0xF807
*** Initializing RF Controller ***
RF: S,A,V,U,V
RF: SATINSTALL,50,C,53,C
RF: L,B -------------------------------------------Identifies Satellite A or B as currently
RF: SATCONFIG loaded for acquisition
RF: F,A,12574,20000,56,0x0100,R,U,3---------------Satellite Configuration Data, Satellite A
RF: F,A,12574,20000,56,0x0100,R,U,3
RF: F,A,12383,20000,56,0x0100,L,U,3
RF: F,A,12383,20000,56,0x0100,L,U,3
RF: F,B,12370,20000,56,0x1004,R,U,3---------------Satellite Configuration Data, Satellite B
RF: F,B,12370,20000,56,0x1004,R,U,3
RF: F,B,12326,20000,56,0x1004,L,U,3
RF: F,B,12326,20000,56,0x1004,L,U,3
RF: RF PCB Version X.X ---------------------------Current RF software revision
RF: DVB/DSS 4
RF COMM: PASS-------------------------------------PASS is expected
*** Initializing Antenna ***
*** NO GPS-Default Used ***
GPS: EXPRESSVU AZ = 208.5, EL = 38.1
Limit Switch Test
GPS: UTC: 083000.00, Lat: 4131.00N, Long: 7115.00W----GPS data from NMEA port
GPS: ECHO_119 AZ = 238.9, EL = 22.1---------------Calculated satellite position based on GPS
Limit Switch Status: PASS-------------------------PASS is expected
*** Initializing Ext Sensor ***
˛=h,0˛S˛=h,1
RF: S,B,H,U,V
ES Status = @@
˛=h,0˛5˛=h,1
ES Cal Score = 991--------------------------------Confirmed data from external sensor
EXT SENSOR: PASS