Controls, English, 7input sel. switch – Kenwood KAC-X4D User Manual
Page 10: A b position, A position, 8input sensitivity control (a.ch/b.ch), 9filter frequency control (a.ch/b.ch), 0filter switch (a.ch/b.ch), Hpf (high-pass filter) position, Off position
10
English
Controls
INPUT
SENSITIVITY[V]
FILTER
FREQUENCY[Hz]
0.2
5
1
0.5
2
4
0.3
3
[MIN]
[MAX]
LPF
OFF
HPF LPF
FILTER
OFF
HPF
A
B
LOW
HIGH LOW
FREQ.RANGE
HIGH
B
A
A
B
B
A
0.2
5
1
0.5
2
4
0.3
3
[MIN]
[MAX]
150/7.5K
100/5K
200/10K
50/2.5K
150/7.5K
100/5K
200/10K
50/2.5K
INPUT
SEL
A
A B
7
INPUT SEL. switch
This switch selects the input method of the
signals to be amplified by amplifiers A and B.
• A B position:
Amplifies both of the signals input to amplifiers
A and B.
• A position:
Amplifies only signal input amplifier A with
both amplifiers A and B.
8
INPUT SENSITIVITY control (A.ch/B.ch)
Set this control according to the pre-output level
of the center unit connected with this unit.
NOTE
For the pre-output level, refer to the
<Specifications> in the instruction manual of the
center unit.
9
FILTER FREQUENCY control (A.ch/B.ch)
This control adjusts the frequency band output
from this unit.
The frequency range is set with the "FREQ.
RANGE" switch.
0
FILTER switch (A.ch/B.ch)
This switch allows to apply high-pass or low-pass
filtering to the speaker outputs.
• HPF (High-Pass Filter) position:
The filter outputs the band of higher
frequencies than the frequency set with the
"FILTER FREQUENCY" control.
• OFF position:
The entire bandwidth is output without
filtering.
• LPF (Low-Pass Filter) position:
The filter outputs the band of lower frequencies
than the frequency set with the "FILTER
FREQUENCY" control.
-
FREQ. RANGE swtich (A.ch/B.ch)
This switch selects the range of filter frequency.
=
Cooling fan
XR-4S_KE_1English.indd 10
08.12.25 2:36:53 PM