Kawasaki 840184 - Manual (Page 8)

M ME ET TA AL L C CU UT TT TIIN NG G
N Neevveerr u ussee g gaasso olliin nee o orr aan nyy ffllaam mm maab bllee lliiq qu uiid d aass aa
llu ub brriiccaan ntt.. S Sp paarrkkiin ng g ffrro om m tth hee m mo otto orr m maayy ccaau ussee iitt tto o iig gn niittee iin ntto o ffllaam meess..
• When cutting metals other then copper, brass or aluminum, always use a lubricant,
such as cutting oil, to keep the blade cool. This will prolong the life of the blade as
well as speeding up the cutting process.
• Make sure the work piece is held securely in place. Hold smaller pieces, such as
pipe or conduit, in a vise or attach to the workbench with clamps.
• To eliminate vibration, always cut close to the clamping point.
• When cutting thin sheets of metal, place a piece of plywood on either side to control
vibration and prevent tearing.
M MA AIIN NT TE EN NA AN NC CE E A AN ND D C CL LE EA AN NIIN NG G
A Allw waayyss U UN NP PL LU UG G tth hee tto oo oll ffrro om m tth hee p po ow weerr sso ou urrccee b beeffo orree
cclleeaan niin ng g o orr m maaiin ntteen naan nccee..
T Th hiiss R Reecciip prro occaattiin ng g S Saaw w iiss llu ub brriiccaatteed d b beeffo orree
iitt lleeaavveess tth hee ffaacctto orryy.. This lubrication should last for the life of the tool. No
further lubrication is required.
14
• Put on eye protection.
• Clear the saw of any
foreign material.
• Make sure the work piece is
held securely in place. Hold
smaller pieces in a vise or
attach to the workbench
with clamps.
• Mark out the line to be cut
so it is easily visible.
• Pull the trigger to start the
saw.
• Set the shoe against the work piece.
• When the blade reaches full speed, slowly feed the blade into the work piece.
P PL LU UN NG GE E C CU UT TT TIIN NG G
N Neevveerr ffeeeed d tth hee b bllaad dee iin ntto o tth hee w wo orrkk p piieeccee u un nttiill tth hee b bllaad dee
iiss aatt ffu ullll ssp peeeed d.. IIff tth hee b bllaad dee iiss n no ott aatt ffu ullll ssp peeeed d,, tth hee ssaaw w m maayy kkiicckk b baacckk
ccaau ussiin ng g sseerriio ou uss p peerrsso on naall iin njju urryy..
• Mark out the line to be cut so
it is easily visible.
• Start inside the area to be cut
out.
• Depress the lock-on button
and press the trigger
to start the saw.
• Set the shoe against the work
piece.
• When the blade reaches full
speed, slowly feed the blade into the work piece.
13
OIL