Kunz AcrEase C60K - Manual (Page 10)

Start engine and move throttle toward slow position to disengage choke. The mower blades
clutch will engage as the engine comes up to speed. The mower blades clutch engages at
1850 RPM.
Slow engine speed to idle to allow engine to warm up. This will probably allow the mower blade
clutch to fully disengage.
Adjust engine speed toward fast to fully engage the mower blade clutch. (The full throttle is
located at the first detent position on the throttle control.)
Clutch overheating or failure may occur if engine is not run at full speed in heavy
load conditions.
The engine full speed setting with mower blades running is 3350 RPM.
For Model E60B:
Set the throttle lever in the choke position to set the choke. (The throttle lever is located on the
right side of the engine.)
Start engine and move throttle toward slow position to disengage choke.
Slow engine speed and engage mower blades clutch handle. (The clutch handle is located at
the front of the mower under the engine.)
Note: Some belt squealing may occur on engagement. This is normal for a manual clutch
engagement design.
If the mower’s engine happens to quit while in use take care to remove the wing
mower from the uncut area before attempting to engage the clutch. Also inspect the
blades for any obstructions that may prevent blade engagement. Failure to do either
may result in premature belt failure or even a fire.
Adjust engine speed to fast position for full throttle. (The full throttle is located at the detent
position on the throttle control.)
E. SHUTTING OFF WING MOWER
Shift to neutral, disengage power to the mower deck, and set the parking brake
before dismounting the tow vehicle.
For Models H60T & C60K:
Set the throttle to slow so the mower blades clutch will disengage.
Allow engine to cool down for a short time before turning the engine off.
9