Kenwood KDC-2016 - Manual (Page 24)

English
— 24 —
Troubleshooting Guide
The following messages are displayed when certain problems are occurring in your system. Take the
recommended actions.
Nothing has been recorded on the MD.
] The next MD will automatically be played.
E-10
No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
] Load the disc magazine properly.
No CD in the unit.
] Insert the CD.
E-01
No disc has been loaded in the disc magazine.
] Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD is scratched a lot.
] Clean the CD and load it correctly.
E-04
No tracks are recorded on the MD, although it has a title.
] The next MD will automatically be played.
E-11
The unit is malfunctioning for some reason.
] Press the reset button on the unit. If the "E- 77" code does not disappear, consult your nearest service center.
E-77
The protective circuit in the unit activates when the temperature inside the automatic disc changer exceeds 60°C (140°F),
stopping all operation.
] Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F),
the disc will start playing again.
E-0d
No disc has been loaded in the disc magazine.
] Load a disc into the disc magazine.
E-02
Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.
] Check the disc magazine. And then press the reset button on the unit. If the "E- 99" code does not disappear, consult your
nearest service center.
E-99
The faceplate of the slave unit being connected to this unit has been removed.
] Replace it.
E-30
KDC-4016_U.Sr2 02.5.15 10:16 AM Page 24