Kenwood KDV-C820 EN - Manual (Page 29)

— 29 —
The use of any accessories except for those provided might result in
damage to the unit. Make sure only to use the accessories shipped with
the unit, as shown above.
1. To prevent short circuits, remove the key from the ignition and
disconnect the - terminal of the battery.
2. Make the proper input and output wire connections for each unit.
3. Connect the wire on the wiring harness.
4. Install the unit in your car.
5. Reconnect the - terminal of the battery.
If you connect the ignition wire (red) and the battery wire (yellow)
to the car chassis (ground), you may cause a short circuit, that in
turn may start a fire. Always connect those wires to the power
source running through the fuse box.
• If your car is not prepared for this special connection-system,
consult your Kenwood dealer.
• Make sure that all wire connections are securely made by
inserting jacks until they lock completely.
• If your vehicle's ignition does not have an ACC position, or if the
ignition wire is connected to a power source with constant
voltage such as a battery wire, the power will not be linked with
the ignition (i.e., it will not turn on and off along with the
ignition). If you want to link the unit's power with the ignition,
connect the ignition wire to a power source that can be turned
on and off with the ignition key.
• If the fuse blows, first make sure that the wires have not caused
a short circuit, then replace the old fuse with one with the same
rating.
• Insulate unconnected wires with vinyl tape or other similar
material. To prevent short circuits, also do not remove the caps
on the ends of the unconnected wires or the terminals.
• After the unit is installed, check whether the brake lamps,
indicators, wipers, etc. on the car are working properly.
2CAUTION
2WARNING
Accessories Installation Procedure
.........1
1
External view
......... Number of items
External view
......... Number of items
.........1
2
.........4
3
.........6
4
.........1
8
.........4
9
.........1
0
.........1
!
.........1
5
.........1
@
.........1
#
.........1
$
.........1
6
.........1
7
1 6 NO. 2 7 3 8 4 9 5 10
NO.
.........1
%
KDV-C810_U.S_r02 02.12.16 12:52 PM Page 29