Kathrein UFD 345 - Manual (Page 12)

Receiver operation
12
Stereo- / Mono- / Channel changeover
Broadcasts can be transmitted in the two-tone channel method
(e.g. original tone “English" on channel 1, “German" tone on channel 2).
•
Press the key. Each time you press the key, you switch the sound chan-
nel in the order:
Stereo
→
Channel 1
→
Channel 2
→
Stereo
•
The selected channel is shown on the screen.
The setting is not saved. After a change in programme the programmed setting
takes effect again.
Video recorder playback (VCR)
For playback from the video recorder, the satellite receiver needs to switched on to
ensure the signal path is switched through from the VCR Scart socket to the TV
Scart socket.
SAT/TV changeover
Where the satellite receiver and TV set are connected via a Scart cable, many TV
sets immediately switchover signal input to video reception (on the Scart socket)
when the satellite receiver is turned on. The switching voltage of the TV Scart
socket therefore needs to be switched off if you want to view a terrestrially broad-
cast TV programme.
•
Press the key.
The switching voltage on pin 8 of the TV Scart socket is turned off, and it is turned
on again by pressing once more.
In Sat mode, “Sat mode” is displayed on the screen for approximately 3 seconds.
Operating the receiver without remote control
On connecting the satellite receiver to the supply, the unit always reverts to the last
operating mode it was in prior to being switched off.
If the unit was disconnected from the supply whilst in standby mode, it reverts to
standby mode on reconnection to the supply. If you happen to have mislaid the re-
mote control handset, you can switch the receiver on by simultaneously pressing
both keys on the infrared sensor.
You can switch between the “TV” and “Radio” operating modes in the same
manner.
Swapping, sorting and copying programmes
With the function: “Swapping, sorting (inserting) and copying programmes” you can
adapt the programme order to suit your individual requirements..
•
If you want to alter the current programme order, you can do this with the func-
tions:
−
Swap programme slots or
−
Insert programme slot (sort) or
−
Copy programme slot.