Position control screen, Equalizer control screen, Dsp control function – Kenwood VZ907 User Manual

Page 32: 32 english

Advertising
background image

32

English

DSP Control Function

Equalizer Control Screen

Selecting the Equalizer Mode:

Each time touch the [

M

] or [

?

] to switch the equalizer mode.

Equalizer Adjustment:

Each time touch the [

2 ] or [ 3 ] ,the selectable frequency band

changes
Each time touch the [

5 ] or [ ∞ ] ,the equalizer level for the selected

band will increase or decrease.

When adjusting the equalizer level, do not adjust solely a single band.
Adjust each band to form a curve.

Compression Adjustment:

This feature raises the level of low sounds so they are not covered over by
road noise when listening to music with broad dynamic range such as
classical music, so that even these low sounds can be heard without having
to adjust the volume.

Touch the [ Step1 ] , [ Step2 ] and [ Step3 ] ,the DSP bass boost can be
adjusted as follows.
[ Step3 ] : High compression ratio.
[ Step2 ] : Middle compression ratio.
[ Step1 ] : Low compression ratio.
[ OFF ] : No compression of the dynamic range.

Ending Equalizer Control Screen:

Touch the [ OK ] to return the DSP control screen.

NOTE

Position Control Screen

Position Select:

Touch the [ FrontR ], [ FrontL ],[ Front ],[ Rear ]and [ All ],the listening
position will be switched in the following order.
[ FrontR ] : Centered on the front right seat.
[ FrontL ] : Centered on the front left seat.
[ Front ] : Centered on the front seat.
[ Rear ]

: Centered on the rear seat.

[ All ]

: Center of the passenger cabin.

Room Size Adjustment:

Touch the [ Large ] , [Mid ] and [Small ], the room size can be adjusted
as follows.
[ Large ] : For large vans or RVs where front and rear speakers are far

apart from each other.

[ Mid ] : For sedans.
[ Small ] : For compact cars where front and rear speakers are close to

each other.

Room size cannot be adjusted when position select mode is set to
" All " and SFC select mode is set to " BYPASS " .

Ending Position Control Screen:

Touch the [ OK ] to return the DSP control screen.

NOTE

POSITION SELECT

ROOM SIZE

OK

POSI CONTROL

Large

Front

FrontL

All

FrontR

Rear

Mid

Small

EQUALIZER

COMP

DANCE

SCREEN CONTROL

EQ CONTROL

OK

OFF

Step3

Step1

Step2

Advertising