Kawasaki VULCAN 1700 VOYAGER - Manual (Page 4)

z Install the antenna base from the outside of the trunk. Install
Belleville (curved) washer and locknut onto the threaded brass
post. Do not over-tighten as this may damage the plastic base.
z Remove the right rear trunk bolt and install the provided metal
grounding bracket at this point and to the lower mounting hole
of the antenna base.
z Connect the black wire with white marking tape from the CB
antenna cable to the lower threaded hole in the antenna base
with the provided Philips head screw.
z Install remaining ring terminal from the antenna cable onto the
brass post and lock down with lock washer and cap nut.
z Install the antenna mast with star washer and confirm the
vertical positioning of the mast matches that of the AM/
FM antenna. Adjust the positioning of the AM/FM antenna
accordingly. Tighten the mast securely but do not over tighten.
NOTE
o Do not use thread locking compound on the threads of the
antenna mast as this may damage the plastic.
z Switch the ignition to “accessory” and turn the radio on, then
follow the Owners Manual to select the “CB on” function. The
CB channel in the lower left corner of the radio display should
show the CB channel number. If the channel number does
not show, check all connections and the accessory fuse. After
proper CB operation is confirmed, switch off the ignition.