Kenko INNOVATIVE STRONG PAN-TILT HEAD MVH-2D - Manual (Page 4)

3.SET CAMERA Camera direction is same as diagram.
Balance of camera and lens must be
center and tight screw. Screw
position is possible to slide.
Attention!
This unit can hold Max.5kg camera
(balance height 6cm). Not in balance
will diminimize functions.
4.SET CABEL Remote controller cable (10) put on
Unit (9) same as diagram direction.
OPERATION
Power switch (13) ON • Speed control
Speed control lever (11)
slid to left be low Right is High
speed.
Not possible to adjust Pan and Tilt
separately.
Attention!
Tilt speed will be change depend on
weight of camera or direction.
• Function
Control lever function is same as
diagram direction.
Possible to move Pan and Tilt same
time.
Attention!
After use make power switched off.
SLIP FUNCTION FOR PAN
Pan (Horizontal) by remote control is from [ 0 ] point left or right about 150º each.
This unit have slip system Fix stand (7) and body. Anytime possible to turn by hand.
Attention!
Tilt (vertical) have NO slip system. Don’t push.
When use slip function be careful to handle for cableing.