Kenwood KRF-X9090D - Manual (Page 31)

31 EN
Presetting radio stations manually
The RDS auto memory function assigns preset numbers to RDS stations
starting from preset number “1”. Therefore, be sure to execute the RDS
auto memory function before using the following operations to manually
store AM stations and other FM stations, and RDS stations. See
“Presetting RDS stations (RDS AUTO MEMORY)”.
¤
MULTI CONTROL
MEMORY/ENTER
1
Tune to the station you want to store.
2
Press the MEMORY/ENTER key while receiving the station.
Blinks for 20 seconds Lights for 20 seconds
L
SL S SB SR
C R
LFE
SP MUTE
A B CLIP
MEMORY
STEREO
AUTO
STEREO
TUNED
Proceed to step 3 within 20 seconds.
(If more than 20 seconds elapse, press the MEMORY/ENTER
key again).
3
Use the MULTI CONTROL knob to select one of the station
presets (1 – 40).
4
Press the MEMORY/ENTER key again to confirm the setting.
• Repeat steps 1, 2, 3, and 4 to store as many stations as
necessary.
• If you store a station at a previously used preset, the old station will
be replaced by the new one.
Listening to radio broadcasts
Receiving preset stations
Numeric keys
TUNER
1
Press the TUNER key to select tuner as the source.
2
Enter the number of the preset station you want to receive
(up to “40”).
Press the Numeric keys in the following order:
For “15”, press 0,5
For “20”, press 0,0,)
• If you make a mistake entering a two digit number, press the +10
key repeatedly to return to the original display and start again.
L
SL S SB SR
C R
LFE
SP MUTE
A B CLIP
STEREO
AUTO
STEREO
TUNED
Receiving preset stations in order (P.CALL)
1
Press the TUNER key to select the tuner as the source.
2
Use the P.CALL 4 / ¢ keys to select the desired station.
• Each time you press the key, another preset station is received in
order.
Pressing the P.CALL ¢ does the following:
Pressing the P.CALL 4 does the following:
Holding down the P.CALL 4 or ¢ key, lets you skip through
the presets, receiving each preset station at 0.5 second inter-
vals.
05.7.16, 0:41 PM 31