Kathrein UFD 400 - Manual (Page 27)

Initial settings
27
(factory preset)
See also video setup menu, menu lines: Polarisation and Orbit Position.
Tone burst and DiSEqC signal
If more than four control criteria are needed in a receiving system, a
DiSEqC control signal is required.
Which of the two setting options is required: “Tone Burst“ or “DiSEqC“
depends on the components of the receiving system.
Thus take into account the specifications of the components present in the receiv-
ing system (switch-over matrices).
Tone burst
In the “Tone burst“ menu entry the following settings of the 22 kHz signal are pos-
sible:
Switching states on setting: Switching states on setting: Switching states on setting:
22 kHz signal —> High/Low and
Tone burst —> Pos. A/B:
22 kHz signal —> Pos. A/B and
Tone burst —> Opt. A/B
22 kHz signal —> Pos. A/B and
Tone burst —> High/Low
Low
High
22 kHz
22 kHz Off
On Pos Tone burst 22 kHz Low
High
Tone burst
Tone burst 0
1
Pos. 1
Pos. 2 Tone burst
Tone burst 0
1
1
2
3
4 0
0
1
1 Off
On
Off
On
Pos. 1
Pos. 2 22 kHz
22 kHz Off
On
DiSEqC
Up to 16 inputs can be switched with the “DiSEqC“ control signal.
•
If the receiver is connected to a “DiSEqC" switch-over matrix, set the menu en-
try to “On”.
Note For optimal usage it is essential to know the switching criteria and the input as-
signments of the DiSEqC switching matrices.
Thus take into account the specifications of the DiSEqC switching matrices or get
in touch with the installer of the receiving system.
DiSEqC repeat
If the receiver is operated on a receiving system with two or more DiSEqC switch-
ing matrices connected in series (cascaded), the DiSEqC command must be re-
peated.
•
In this case set the menu entry “DiSEqC Repeat" to “1" or “2“.
Default: Off
UFO mini
With a “Subscriber-controlled preprocessing system" the receiver‘s input frequency
is adjusted to a fixed input frequency. The signals are transmitted by the “Sub-
scriber-controlled preprocessing system“ on this frequency. The reception pa-
rameters for the programme selection are transmitted by “DiSEqC“ command
to the receiving system and set up there.
Which setting needs to be selected, "On" or “UFO twin 1“ or “UFO twin 2“, is de-
pendent on the design of the “Subscriber-controlled preprocessing system“.
The “UFO mini Twin“ design is a special form of the “Subscriber-controlled pre-
processing system“