Kyocera TNT VMS200 - Manual (Page 9)

User Guide 1
1 G
ETTING
S
TARTED
Phone battery
Installing the battery
To install the battery:
1.
With the back of the
phone facing you, locate
the notch near the
bottom of the phone.
2. With your thumbnail in
the notch, lift up on the
back cover to remove it.
3. Place the battery in the
phone casing with the
metal contacts toward
the top of the phone.
4. Replace the back
cover and press to
snap it into place.
Note: Before removing the
battery, make sure the phone
is turned off.
Charging the battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
1.
Connect the AC adapter
to the jack on the side
of the phone.
2. Plug the adapter into a
wall outlet.
The battery icon on the right side of the external
screen shows whether the phone is:
• Charging (animated icon)
• Partially charged
• Fully charged
Warning: The battery does not charge if you are
in a call while it is connected to an AC adapter.
Recharging the battery
You can safely recharge the battery at any time,
even if it has a partial charge.
82-K8214-1EN.book Page 1 Tuesday, May 27, 2008 5:36 PM