Kambrook JAGUAR KBV70 - Manual (Page 6)


CLEANING AND REPLACING
fILTERS
Filters must be cleaned from time to time (at
least twice a year) to remove the fine dust
particles that have been collected.
1. Remove the dust container from the unit
by pressing down on the “Press and llift”
button
2. After removing the dust container, hold
steadily on the dust container and twist the
lid clockwise until ‘click’ sound is heard and
the lid of the dust container is detached.
3. Take off the combined mesh and HEPA
filter by holding steady on the lid of the dust
canister and twisting the combined mesh
and HEPA filter anti-clockwise
4. Tap and shake the filter until all the fine
dust particles are removed. However, after
approximately 6 months the filter should be
replaced.
5. To place the filter back in the dust canister
simply place the combined mesh and HEPA
filter in the dust container lid and turn the
filter in a clockwise direction until ‘click’
sound is heard to lock it in place.
6. To fully assembled the dust filter unit,
simply placed the combined filter and lid
together with the dust container. Hold
steady on the dust container and twist
the lid in anti-clockwise direction until it’s
clicked in place.
7. Place the complete dust container assembly
back in the vacuum cleaner for next use.
Ensure the bottom of the dust container is
closed prior to replacing the dust container.
MOTOR PROTECTION fILTER
The motor protection filter must always be in
place when operating the vacuum otherwise
damage to the motor may occur.
To replace the motor protection filter
- remove the dust container. The motor
protection filter is located at the bottom of
the inner chamber. Pull the filter upward to
remove then simply replace the new filter.
EXHAUST fILTER
The exhaust filter should be cleaned every
six months. Simply unclip the grill at the back
of the vacuum cleaner and shake and tap the
filter to remove any dust accumulated. Then
relocate the filter and reattach the grill.
CARE AND MAINTENANCE
Always switch appliance off, then switch off
at the power outlet and unplug the appliance
prior to cleaning or replacing either filter.
To clean the outside of the unit, wipe the
exterior with a soft, damp cloth. Never use
an abrasive cleaner.
CHECK AND REPLACE BOTH THE
MOTOR PROECTION AND HEPA FILTERS
APPROXIMATELY TWICE A YEAR OR
WHEN VISIBLY CLOGGED