Kenwood KRC-708 - Manual (Page 41)

— 41 —
FRONT • L
FRONT • R
REAR • L
REAR • R
P.CONT.
ANT.
CONT.
ILLUMI
EXT. CONT
Connecting Wires to Terminals
When only two speakers are being connected to the system, connect the
connectors either to both the front output terminals or to both the rear output
terminals (do not mix front and rear). For example, if you connect the +
connector of the left speaker to a front output terminal, do not connect the -
connector to a rear output terminal.
2CAUTION
If you connect the ignition wire (red) and the battery wire (yellow) to the car
chassis (ground), you may cause a short circuit, that in turn may start a fire.
Always connect those wires to the power source running through the fuse
box.
2WARNING
FM/AM antenna input
Rear left output (White)
Rear right output (Red)
Fuse (10A)
KENWOOD disc changer /
DAB control input
Wiring harness
(Accessory1)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left
speaker
To front right
speaker
To rear right
speaker
To rear left
speaker
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Ignition key
switch
Car fuse
box
(Main fuse)
ACC
Car fuse box
Battery
If no connections are made, do not let the wire come out from the tab.
Front left output (White) Front right output (Red)
To connect the Disc changer or
DAB unit, consult each manual.
NOTE
Power control wire (Blue/White)
Motor antenna control wire (Blue)
Dimmer control wire (Orange / White)
When using the optional power amplifier, connect
to its power control terminal.
To car light control switch
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or
to the power terminal for the booster amplifier of the
film-type antenna.
External amplifier control wire
(Pink / Black)
To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
Non-fading right output(Red)
(KRC-X858 only)
Non-fading left output
(White) (KRC-X858 only)
KRC-X858_U.S-4 00.12.27 0:13 PM Page 41