Kenmore 625.343920 - Manual (Page 7)

7
INSTALLATION STEPS
STEP 4 - MAKE TUBING CONNECTIONS
1. Allowing some slack, measure and cut a length of
3/8" tubing to connect between the tubing adaptor, at
the supply saddle valve, and the filter system inlet,
FIG. 1. Cut the ends of the tubing square.
2. Slide a compression nut onto both ends of the tubĆ
ing. At the filter system end, push a tubing insert into
the tubing.
3. Connect the tubing and tighten the compression
nuts securely.
4. Repeat steps 2 and 3 to connect tubing between the
filter system outlet and the adaptor on the bottom of
the faucet stud, FIG. 1.
STEP 5 - BATTERYPACK INSTALLATION
AND CONNECTION, DELUXE MODEL ONLY
1. In a dry location, within reach of the electronic base
3 ft. leadwire, select a place for the battery pack (see
FIG. 1). The battery pack attaches to most surfaces
with a `` sticky-back'' Velcro strip.
2. The battery pack uses 2, size AA batteries. Check
to be sure they are installed correctly. Then, remove
the paper backing on the Velcro strip and secure in
place.
3. Fasten the electronic base leadwire connector and
battery pack connector together.
STEP 6 - FILTER CARTRIDGE INSTALLATION
Turn to page 9 and follow all steps under ``Filter Cartridge Replacement''.