Krell Industries EVOLUTION TWO MONAURAL PREAMPLIFIER - Manual (Page 24)

20
Remote Control Description
See Figure 2 on page 16
The Evolution Two Monaural Preamplifier remote provides all of the power, pream-
plifier, level control, and navigate/customize functions outlined under Front Panel
Description, pages 17-19. The remote control provides additional functions,
including CD functions and menu configuration, accessed using only the remote
control keys.
Battery Installation and Removal
The Evolution Two preamplifier remote control uses 2 AAA-size 1.5 Volt batteries.
Batteries are included with the shipment. To install the batteries:
1. Remove the remote control backplate, using the supplied T-10 Torx wrench.
2. Install the batteries, following the battery position diagram on the plastic bat-
tery receptacle.
3. Replace and secure the backplate.
Notes
Replace batteries when remote control function becomes intermittent.
Remove batteries if the remote control is not used for a long period of time. Battery leakage
can damage the remote control.
Preamplifier Functions
21 Main Bus Key
Use this key to select the input for the main bus output. The red main LED illu-
minates, when this function is selected. For more information, see Play and
Record, on page 30.
Level Control
22 Bal(ance Key)
Use this key, along with level keys or the level control knob (16) on the pream-
plifier chassis to balance left and right output levels. The front panel display
(15) shows the left and right balance offset.
(SECTION FOUR: Anatomy of an Evolution Two continued)