Kompernass KH 2024 - Manual (Page 11)

10
made, then the current settings are activated and the
device goes back into automatic operation.
2.5 Checking the world time
• Press »MODE« ቫ four times if the device is in time
display mode.
• Press »MODE« ቫ five times if the device is in radio
mode.
• If the device is already in "Setting the local time" mode
as described in Section 2.4, you can enter "Checking the
world time" mode by pressing the »MODE«
ቫ button
once.
• The last time zone is displayed steadily in the hours and
minutes part of the display, while on the right the code
for the appropriate city starts to flash. The display
shows "CITY" above steadily.
• You can select the required time zone by pressing the
»UP« or »DOWN« buttons in accordance with the table
in Section 2.4.
• Press »SNOOZE« to change the display. The display
'SUN' shows the remaining daylight.
• If »MODE« ቫ is pressed once, or if no further setting
is made within 15 seconds, the device shows the
frequency if the radio is on, or if not, the time again.
2.6 Sleep Timer
• Press »SLEEP/RADIO ON« ቦ once to check the sleep
timer current setting. If the Sleep Timer is not activated,
then the display briefly shows "ON" (radio switched on).
• Press »SLEEP/RADIO ON« ቦ once again to change the
current setting. (in decrements of 10 minutes, from 90-
10 minutes). The radio remains switched on and the
selected band appears in the lower area of the LCD.
• Press »SLEEP/RADIO ON« ቦ when the display reaches
desired number of minutes/duration for the Sleep Timer
(e.g. "10" for 10 minutes). "OFF" switches off the radio.
• If within 15 seconds there has been no further setting
made, then the current settings for the Sleep Timer are
activated and the device goes back into automatic
operation.
2.7 Setting ALARM 1 and ALARM 2
• Press the »AL. 1« ቤ or »AL. 2« ቧ button once. 'AL 1'
or 'AL 2' is displayed steadily in the alphanumeric
KH_2024_GB 23.07.2003 10:57 Uhr Seite 10