Kenmore IntelliSoft 350 Series 625.383560 - Manual (Page 24)

24
Faceplate Timer Features
4. Press SELECT again to show the following
RECHARGE display.
EXAMPLE: Set to 4 days maximum between
regenerations.
Maximum Days Between Regenerations: The
face plate timer automatically controls regeneration
frequency. This provides the greatest operating effi-
ciency, and under most conditions this feature will be
left in its default mode. However, you can modify this
feature if you want to force a regeneration every set
number of days. For example, if your water supply
contains iron and you want the softener to regener-
ate at least once every few days to keep the resin
bed clean, set the display as typically shown above.
Setting is available from 1 to 6. Press SELECT to
return to the present time is play.
5. Press SELECT to show the 97% display.
IntelliSoft 97% Feature: The 97% Feature is an inte-
gral part of the IntelliSoft water and salt saving sys-
tem. When this feature is ON, the softener will auto-
matically recharge when 97% capacity has been
used, at any time of day. The default is ON. If this
feature is not desired, turn it off by pressing the
DOWN button.
6. Press SELECT to show the 12 HOUR display.
12 or 24 hour clock: All time displays are shown in
standard clock time (1 to 12 PM; and 1 to 12 AM) at
the 12 hr default setting. If Military time displays are
desired, set to 24 hr by pressing the UP button.
WATER FLOW THROUGH THE SOFTENER
If soft water is in use, the water flow bars continually
scroll across the display. The bars scroll slowly when
water flow is slow, and move faster as water flow
increases. The flow bars do not show when all faucets
and water using appliances are off.
TIME TIME
AM
PM
RECHARGE RECHARGE
RECHARGE RECHARGE
DAY DAY
Default Display Example:
Set to 4 Days Maximum
Between Regeneration
FIG. 37
Questions? Call The Kenmore Water Line 1-800-426-9345
Flow bars scroll when
soft water is in use.