Kenwood KRF-A4020 - Manual (Page 5)

KRF-A4020 (En/E2T)
Operations
Preparations
Other
5
Connecting the antennas
Antenna terminal connections
1 Push lever.
AM loop antenna
The supplied loop antenna is for use indoors. Place it as far as
possible from the receiver, TV set, speaker cords and power
cord, and adjust the direction for best reception.
FM indoor antenna
The supplied indoor antenna is for temporary use only. For
stable signal reception we recommend using an outdoor
antenna. Disconnect the indoor antenna when you connect
one outdoors.
FM outdoor antenna
Lead the 75
Ω
coaxial cable connected to the FM outdoor
antenna into the room and connect it to the FM 75
Ω
terminal.
AM loop
antenna
FM indoor
antenna
FM outdoor antenna
Use an antenna adaptor
(Commercially available)
1 Strip coating. 2 Push lever.
3 Insert cord. 4 Return lever.
Connecting the speakers
Right
Front Speakers A
Use the FRONT
SPEAKERS B
terminals if you
want to connect a
second front
speaker system.
Left
Setting up the system
2 Insert cord. 3 Return lever.
• Never short circuit the + and – speaker cords.
• If the left and right speakers are connected inversely or the
speaker cords are connected with reversed polarity, the
sound will be unnatural with ambiguous acoustic imaging.
Be sure to connect the speakers correctly.
Speaker impedance
After confirming the speaker impedance indications printed
on the rear panel of the receiver, connect speakers with
matching impedance ratings. Using speakers with a rated
impedance other than that indicated on the rear panel of
the receiver could result in malfunctions or damage to the
speakers or receiver.
FM
75 Ω
GND
AM
ANTENNA
SPEAKERS
+ - - +
R
+ - - +
L
L R
B
A
SUBWOOFER
PRE OUT
Front Speakers B
Right Left
Powered subwoofer
To produce sound from
the powered subwoofer,
turn the SPEAKERS A
key on. No sound will be
produced if only the
SPEAKERS B key is on.