Kenwood KDC-MP5029VG - Manual (Page 25)

English | 25
• Make sure that the unit is installed securely in place. If
the unit is unstable, it may malfunction (for example, the
sound may skip).
non-Japanese cars
Japanese cars
1 Refer to the section <Removing the hard rubber
frame> (page 27) and then remove the hard
rubber frame.
2 Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and
secure the unit with the accessory screws.
• During installation, do not use any screws except for
those provided. The use of different screws might result
in damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used
with excessive force during the installations.
Installation
Firewall or metal support
Screw (M4X8)
(commercially available)
Self-tapping screw
(commercially available)
Metal mounting strap
(commercially available)
Bend the tabs of the mounting
sleeve with a screwdriver or similar
utensil and attach it in place.
8 mm
MAX.
ø5mm ø5mm
8mm
MAX.
T
N T
N
T/N
T: Toyota cars
N: Nissan cars
Accessory 3...for Nissan car
Accessory 4 ...for Toyota car
3
4
Using the Relay Connector
1 Plug the vehicle’s harness into the relay
connector.
2 Plug the parking brake detection wire into the
relay connector.
Detection wire
Relay connector
Accessory
0
Vehicle harness
2
1
3 Lock the cable clamp.
Cable clamp
3
4 Press down using pliers until the conductive
metal is even with the plastic surface.
5 Lock the lid.
Lid
4
5
Conductive metal