Kodak DVD 40 - Manual (Page 34)

34
Others
Remote Control Preparation
Open the cover.
INSERT BATTERIES
1
Insert batteries. 2
Close the cover. 3
Notes:
Improper use of batteries may cause battery leakage and
corrosion. To operate the remote control correctly,follow
the instructions below:
Do not insert the batteries in the wrong direction.
Do not charge, heat, open, or short-circuit the batteries.
Do not throw batteries into a fire.
Do not leave dead batteries in the Remote Control.
Do not use different types of batteries together, or mix
old and new batteries.
If you do not use the remote control for a long period of
time, remove the batteries to avoid possible damage
from battery corrosion.
If the remote control does not function correctly or the
operating range becomes reduced, replace all batteries
with new ones.
If battery leakage occurs, clean the battery compart-
ment, then insert new ones.
Point the remote control at the remote sensor.
(The pictures below are for reference only).
USING THE REMOTE CONTROL
Remarks:
Do not expose the remote sensor of the DVD Player to a strong
light source, such as direct sunlight.
Notes:
Point the remote control directly at the player's remote
sensor.
Do not leave the remote control in an extremely hot or
humid place.
Do not spill water or put anything wet on the remote
control.
Battery life is 1 year under normal conditions.
Make sure to match the "+" and "-" of the bat-
teries with the marks inside the battery com-
partment.
30º 30º
manual dvd-40 EN.qxd 07/10/2004 12:17 PÆgina 34