Kathrein UFE 371/S - Manual (Page 21)

Installation Menu
21
In this menu, you can carry out the programme search.
1) AutoScan
All channels in the range of 177 MHz to 858 MHz are
searched for programmes.
2) Net Scan
The entire network is searched for network information.
(Results only if this information is transmitted with the
programmes).
3) TP Scan
Search for individual channels.
4) PID
Enter audio and video PID for a detailed search for individual
programmes.
5) Scan Mode
Selection of: All or FTA (free-to-air programmes only) – when
you run a programme search for all programmes, all
programmes are stored, including the encoded transmitters;
otherwise, only the free programmes are stored.
Programme Scan:
Note: In addition to the indicator of reception intensity and reception quality,
the receiver has an assist function with a acoustic signal for adjusting
the antenna, you can activate in this menu by pressing the Mute key.
With the red key you can start the programme search for the entire
frequency range. The receiver prompts you to confirm that you wish to
delete the existent programmes. If you confirm with «JA», all the
allocated programmes are deleted and the new programming entered
in the main list (in order of the factory-set pre-programming at the
factory).
If you select «EXIT», the programme search will not be started.
Note: Should you be in the catchement area of two DVB-T networks, it
may happen that you find some channels twice in your
programme list after you run the “AutoScan”. You can leave them
as they are, or you can decide in favour of the programme which
provides the better image (reception), and delete the other one.
Start the scan by pressing the green key for a specific channel. The
programmes that are found will be added on the end of the programme
list.
PID (Programme Identification) input:
Press the yellow key, enter the video PID and the audio PID, and
press the yellow key again. The programme, identified with «TV CH»,
will be placed at the end of the main list.