Keyspan USA-49WG - Manual (Page 4)

4
3.1 – Installation Instructions
Installing the USB 4-Port Serial Adapter Software for Windows Operating Systems
Step 1 – Insert the Keyspan Serial Adapter CD-ROM.
Turn your computer ON. When your computer starts up, place the Keyspan USB 4-Port Serial Adapter CD into the CD-
ROM drive.
Step 2 – Run the Keyspan USB Serial Software for Windows Installer.
If the Keyspan Adapter is connected to your computer, disconnect it now.
Locate the Windows driver and double click on it to begin driver installation.
Follow the instructions on-screen to complete the installation.
Step 3 – Software Installation Complete!
Now that you have installed the Keyspan USB 4-Port Serial Adapter software, you are ready to install the Keyspan
USB 4-Port Serial Adapter hardware.
Installing the Keyspan USB 4-Port Serial Adapter Hardware
Step 1 – Connect the USB Cable to the Adapter.
If your Keyspan adapter does not have an attached USB cable, attach the included USB cable into the Keyspan
adapter’s USB port.
Step 5 – Connect the Adapter to Your USB Port.
Attach the Adapter to your computer by connecting the Adapter’s USB cable into any built-in USB port on your com-
puter or USB hub. It is necessary to turn off your computer when attaching the Adapter.
Step 6 – Hardware Installation Complete!
Your Keyspan USB 4-Port Serial Adapter is ready for use now that you have installed hardware and software.