Kustom KPM 8420T - Manual (Page 7)

100 250 500 1K 4K 10K 2K
-12
0
-6
+6
+12
Limiter
+6
+3
0
-5
-10
Feedback Notch Playback Volume Monitor Volume
Monitor
100 250 500 1K 4K 10K 2K
-12
0
-6
+6
+12
Limiter
+6
+3
0
-5
-10
Feedback Notch Playback Volume Main Volume
Main
19
20 21 22
23
24
25
26 27 28
29
30
MAIN AND MONITOR MASTER
MONITOR MASTER
MONITOR MASTER GRAPHIC EQ:
FEEDBACK NOTCH :
PLAYBACK VOLUME
MONITOR MASTER
MAIN MASTER GRAPHIC EQ:
FEEDBACK NOTCH :
PLAYBACK VOLUME
MAIN MASTER
(MONITOR)
(MONITOR):
Control:
(MAIN)
(MAIN):
Control:
This set of slide controls adjusts specific
frequencies in order to tailor the overall sound to
an acoustical environment or an intended sound.
This control is a narrow notch that can remove a
problem frequency that may causing excessive
feedback. To activate this feature, slowly turn the
control to find the feedback problem area. This
subtlety turns down a small area of frequencies,
thus removing the feedback without greatly
affecting the overall sound. Turning this knob full
counter-clockwise will defeat the feedback filter.
This control adjusts the amount of input from the
Playback input jacks (Rear Panel). This set of
Stereo RCA jack will accept any Line-Level audio
sources such as: CD, MP-3, DVD, HARD DISC &
TAPE PLAYER. NOTE: This controls passes
signal directly to the MONITOR Master section
and is not affected by the Channels ON/MUTE
function.
This control adjusts the master volume of the
Monitor section.
MONITOR LED METER
LIMITER LED
MAIN LED METER
LIMITER LED
:
:
:
:
This indicates the level of Monitor Preamp output.
The number values are in dBV (1VRMS = 0dBV).
This indicates Power Amp A has reached full
clean output. If the input signal to the power amp
increases after the LED is lit, it will be limited to
protect the speakers. Because this limiter is built
into Power Amp A, the LED only shows that the
monitors are at full output when assigned to it (See
page 9 for information on assigning power amps).
This set of slide controls adjusts specific
frequencies in order to tailor the overall sound to
an acoustical environment or an intended sound.
This control is a narrow notch that can remove a
problem frequency that may causing excessive
feedback. To activate this feature, slowly turn the
control to find the feedback problem area. This
subtlety turns down a small area of frequencies,
thus removing the feedback without greatly
affecting the overall sound. Turning this knob full
counter-clockwise will defeat the feedback filter.
This control adjusts the amount of input from the
Playback input jacks (Rear Panel). This set of
Stereo RCA jack will accept any Line-Level audio
sources such as: CD, MP-3, DVD, HARD DISC &
TAPE PLAYER. NOTE: This controls passes
signal directly to the MONITOR Master section
and is not affected by the Channels ON/MUTE
function.
This control adjusts the master volume of the Main
section.
This indicates the level of Main Preamp output.
The number values are in dBV (1VRMS = 0dBV).
This indicates Power Amp B has reached full clean
output. If the input signal to the power amp
increases after the LED is lit, it will be limited to
protect the speakers. Because this limiter is built
into Power Amp B, the LED only indicates the
Mains are at full output when assigned to it (See
page 9 for information on assigning power amps).
MAIN MASTER
7