Kawasaki 19.2V BATTERY-OPERATED WORKLIGHT 690081-1HR User Manual
Page 7
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on
another tool.
Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets.
If you must use an extension cord, be sure that the gauge is large enough to carry
the amount of current necessary for your power tool. If not, your tool may
experience a loss of power, excessive voltage drop or overheating. The smaller the
gauge number, the heavier the cord (see table below).
RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT AC 60 HZ TOOLS
TOOL CURRENT RATING
CONDUCTOR SIZE IN A.W.G
AMPERE
10FT.
25FT.
50FT.
100FT.
3-6
18
18
18
18
6-8
18
18
18
16
8-10
18
18
18
14
10-12
16
16
14
14
12-16
14
12
12
-
16-20
12
12
12
-
SPECIFICATIONS
SPECIFICATIONS
Voltage
19.2V
Light Bulb Type
Krypton 19.2V 0.6 A
Charger Input
120V
60Hz
Charging Time
Approx. 1 Hour
Battery Type
Ni-Cad
PROTECTING THE ENVIRONMENT
BATTERIES
Alltrade batteries can be recharged many times. At the end of their useful life, recy-
cle batteries with due care for our environment.
Ni-Cad and Ni-MH batteries are recyclable. Take them to your local recycling center
or call 1-800-822-8837. Collected batteries will be recycled or disposed of properly.
1. Remove the battery pack from the
Worklight.
2. Hold the top of the Worklight with
one hand while twisting the rim in a
counter-clockwise direction with the
other. Continue turning until the rim
comes loose.
3. Remove the bulb by turning it slightly
and pulling it out of the bulb fitting.
Be careful not to damage the delicate
parts inside the case.
4. Insert the new bulb, then carefully
put the rim back in place and turn
it clockwise to tighten it.
MAINTENANCE AND CLEANING
Always remove the battery pack before attempting
cleaning or maintenance.
Use only mild soap and a damp cloth to clean the tool. Never let any liquid get
inside the casing. Never immerse any part of the tool in a liquid. Always keep the
ventilation openings clear.
Always clean the battery pack using only a dry cloth. Do not use liquids.
Always unplug the charger before cleaning it.
Regularly clean the ventilation slots in your tool and charger using only a soft
brush or dry cloth.
Never open the Worklight case, battery pack or charger. Do not attempt to repair
the Worklight, battery pack or charger yourself. Opening any of these parts will void
your warranty.
Use only authorized replacement parts for your tool.
Equipment service must be performed only by qualified repair personnel using
authorized replacement parts. Service or maintenance by unqualified personnel
could result in considerable risk of personal injury. Use of unauthorized parts or
failure to follow maintenance instructions may create a risk of electric shock or
injury.
11
12
REPLACEMENT
BULB