Krown Manufacturing KA1000RR - Manual (Page 4)

PROGRAMMING THE KA1000RR MEMORY
To program the KA1000RR, press and hold the light switch but-
ton on the KA1000RR (fi gure 2.1). While holding the light switch
button, press and hold the transmitter test button until the LED on
the light switch button turns off then on one time. The transmit-
ter ID is now recorded into memory of the receiver. To test if the
KA1000RR has accepted the transmitter, press the transmitter test
button to see if the unit begins to fl ash. To stop the fl ashing of the
lamp, press the lamp switch button once.
If the light switch button fl ashes twice when programming the
KA1000RR, the memory is full. Check the number of registered
transmitters or erase any unused transmitters if needed.
ERASING A TRANSMITTER FROM MEMORY
To erase a transmitter from memory, press and hold the test but-
ton of the transmitter and light switch button at the same time. The
KA1000RR will turn off then on twice to confi rm the transmitter
has been removed from memory.
Erasing ALL Transmitters from Memory at ONE time
To clear the whole memory of the KA1000RR, press and hold the
light switch button until the LED fl ashes eight (8) times. This will
clear all transmitters from the receiver.
2 3
Code
1________________________ 9________________________
2________________________ 10________________________
3________________________ 11________________________
4________________________ 12________________________
5________________________ 13________________________
6________________________ 14________________________
7________________________ 15________________________
8________________________ 16________________________