Kenwood KRC-X858 - Manual (Page 8)

General features
— 8 —
English
Function of the KRC-X858
"LPF NF" : Adjust the frequency of the Low-pass filter for Non-
Fading output.
Setting values: 50 Hz / 80 Hz / 120 Hz / Through
• This mode is available only when the non-fading output function
is set to on.( page10).
• Not available during the Dual zone system is on.
NOTE
Function of the KRC-X858
"HPF R" : Adjust the frequency of the High-pass filter for rear
output.
Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /
150Hz / 180Hz / 220Hz
You can separately set the high-pass filter for front and rear
output,including preouts. The high-pass filter works except during
non-fading preout when switching to non-fading. The factory
default settings for front output and rear output are "Through" .
NOTE
Function of the KRC-X858
"HPF F" : Adjust the frequency of the High-pass filter for front
output.
Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /
150Hz / 180Hz / 220Hz
You can separately set the high-pass filter for front and rear
output,including preouts.The high-pass filter works except during
non-fading preout when switching to non-fading.The factory
default settings for front output and rear output are "Through" .
NOTE
Function of the KRC-X858
"NF Level" : Adjust the Non-fading output level.
Setting values: - 15 – + 15
• This mode is available only when the non-fading output function
is set to on.( page10).
• Not available during the Dual zone system is on.
NOTE
"Fader" : Adjust the fader level.
Setting values: Front 15 – Rear 15
"Balance" : Adjust the balance level.
Setting values: Left 15 – Right 15
"Treble" : Adjust the treble level.
Setting values: - 8 – + 8
Function of the KRC-X858
"Tre F" : Adjust the center frequency of the treble.
Setting values: 10.0 / 12.5 / 15.0 / 17.5 kHz
This mode is available only when the Sound coordinate system is
on. ( page36).
NOTE
KRC-X858_U.S-4 00.12.27 0:12 PM Page 8