Kwik Tek 800-553-5953 - Manual (Page 9)

SGF SEAT GRINDER
WHEEL DRESSER SET-UP
1. Loosen handle #3 and rotate the pointer line until it aligns to the index angle desired and
retighten.
2. After attaching the correct grinding wheel to the grinder unit, carefully lower the grinder unit
onto the dresser arbor item #1
3. Loosen item #5 and raise or lower the arbor until the face of the wheel is in relative position
to the diamond (#6). Retighten # 5
4. Adjust the diamond #6 by turning the knurled knob #2 until the diamond is nearly in contact
to the face of the grinding wheel.
5. Start the motor and begin dressing the wheel using handle #4 and slowly sweeping the face.
(Follow the directions below)
6. Slowly feed the diamond in while moving it across the face of the grinding wheel while
moving it with handle #4.
WARNING: Take the lightest cut possible – never jam the diamond into the grinding wheel.
KW Products Inc. 800-553-5953 6.
500 57 th Street, Marion, IA 52302 USA
Copyright 2004 All Rights Reserved
Equipment specifications, options and accessories subject to change without