Kalorik USK STP 20159 - Manual (Page 6)

Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
Print only
what is inside the frame.
6 USK STP 20159 - 110127
Assembly page 6/24
Fax +32 2 359 95 50
• When changing the setting from a higher selection to a lower
setting allow several minutes for the pressing plate to cool
sufficiently after making the change.
Kind of textile
Temperature Steam
Nylon 100°C / 212°F NO
Silk 130°C / 266°F NO
Rayon 140°C / 284°F NO
Wool 160°C / 320°F YES
Cotton 200°C / 392°F YES
Linen 210°C / 410°F YES
NOTE: You may find it more efficient to arrange your fabrics from
those requiring the lowest setting to those requiring the highest
setting and proceed accordingly. This will avoid any unnecessary
delay or wait for the pressing plate to cool.
STEAM CONTROL
• Steam is produced only when the yellow steam ready light is on.
• The green ready light goes off when the unit has reached the
desired temperature. The yellow steam ready light will come on
when the unit is ready to produce steam.
• If this is the first time you are using the steam press or you have
been storing it for some time, lift the pressing plate into the raised
position and press the burst of steam button several times until the
steam begins to flow.
• The burst of steam function can only be used when the steam
ready light is on AND the steam press is in a slightly opened
position. Do not use the burn of steam function when the steam
press is closed, or you may damage the unit.
• Do not press the burst of steam button for more than 5 seconds or
water may drip on your garment.