Keys Fitness ET520D - Manual (Page 7)

Insert the Tension Knob
(54) into the Upright Post
(38) and connect with the
screw attached (55).
5. Connect the Monitor Cable (51) to the Computer (57) and
secure the Computer with the Screws (56) already in the back
of the Computer. Pull the Tension Cable (53) out of the
Handlebar Post (38) and connect to the Tension Knob (54) as
in Steps 1 and 2:
Step 1: Put the Tension Controller cable end
into the spring hook.
Step 2: Pull the Tension Controller cable
into the gap of the bracket.
11
6. Connect the Left Handlebar (64L) to the Left Handlebar Sleeve
(67L) with Bolts (69), Washers (70) and Cap Nuts (71). Then
slide the entire Left Handlebar Assembly onto the Handlebar
Post (38) and secure with Washer (72) and Nut (6a). Once
tightened, slide on the Plastic Cap (73) to cover the nut. Attach
the Left Connect Tube (74L) to the bottom of the Left
Handlebar Assembly using Screw (77), Washers (21) and Nut
(39). Once tightened, slide on the Plastic Cap (78) to cover the
nut.
Repeat step 6 on the right side of the unit.
38
64L
74L
5
6
10
These two parts are
already connected