Konica Minolta DiMAGE Z6 - Manual (Page 56)

56 A
DVANCED RECORDING
AUTO DSP
Automatic Digital Subject Program Selection can be
temporarily disabled in the auto-recording menu. When
disabled, the program exposure mode is active. If the
camera is turned off, Automatic Digital Subject Program
Selection is activated.
ANTI-SHAKE
The Anti-Shake system minimizes the affect of camera shake, a slight blurring caused by
subtle hand motion. Camera shake is more pronounced at the telephoto setting than at
the wide-angle. Anti-Shake is employed when the shutter speed falls below a certain limit
depending on the focal length in use. The effectiveness of Anti-Shake depends on the
shutter-speed in use and the degree of shaking. The system may not work with moving
subjects or when the camera is panned.
Camera-shake
warning
Anti-shake
indicator
When the system is active, the Anti-Shake
indicator appears. Regardless of the Anti-
Shake setting, if the shutter speed is too
slow for the camera to be safely handheld,
the camera-shake indicator appears as a
warning. Use the built-in flash or a wide-
angle zoom position.
Frame the subject as described in the basic operation section and press the shutter-
release button partway down. Confirm the image has stabilized on the monitor and press
the shutter-release button all the way down to take the picture. If Anti-Shake cannot
compensate the camera motion, the Anti-Shake indicator turns red.
Drive mode
Image size
Quality
Auto DSP
Anti-shake Single
2816x2112
Standard
On
Disp. + Exp.