Kambrook Jaguar KHV40 - Manual (Page 3)

5 4
USING YOUR KAMBROOK
DUST HUNTER 2 HAND VAC
Remove all packaging materials and any
promotional labels or stickers from your
Kambrook Jaguar Dust Hunter 2. Ensure
you have removed all of the accessories
before discarding the packaging.
Ensure that the dust bag/filter is correctly
fitted.
Locate either the crush proof hose or
brush and push the connection point into
the suction hole/hose inlet connection at
the front of the unit until a “click” sound
is heard.The brush attachments can be
used alone or can connect to the end of
the crush proof hose.
To use the Hand Vacuum with the
shoulder strap, attach it to the unit as
shown below.
Plug into a 230/240v power point and
switch the power on.
To commence vacuuming, press down on
the on/off switch located on top of the
unit to switch on ( I )
Use your vacuum to pick up dirt, dust,
food crumbs, etc from counters, carpet,
bare floors, rugs, automobile interiors,
upholstered furniture, etc.
When vacuuming is complete, press the
on/off switch to switch off ( O ).Turn the
power off at the outlet and then remove
the power cord from the power outlet
(when removing plug from the power outlet
grasp the plug, not the cord).
ALWAYS ENSURE THAT THE
DUST BAG/FILTER IS CORRECTLY
FITTED. NEVER OPERATE
WITHOUT THE DUST BAG/FILTER
IN PLACE.
Cleaning Tools
Your Kambrook Jaguar Dust Hunter 2
includes the following cleaning tools that
will make your cleaning tasks easier.
Crevice brush – Used
for reaching hard to
clean places such as
the crevice of car
seats, corners and
skirting boards
Dust Brush – Used for
vacuuming delicate
surfaces and areas
such as shelves,
venetian blinds and
furniture.
Turn off the vacuum cleaner when
changing any attachments
Cleaning Dust Cup & Dust
Bag/Filters
Dirt and debris picked up by your vacuum
will collect in the dust cup.The dust cup
should be changed when full.
To empty the Dust Cup, follow these
steps.
Always switch the unit off, then switch off
at the power outlet and unplug the unit
prior to emptying the dust cup or
replacing the dust bag/filter.
To open the dust bag compartment, press
the ‘Filter Release’ button located on the
side of the unit, the cover will then open
Pull out the dust bag/filter, by grasping the
side of the filter and pulling out.
Empty the dust from the dust cup.
The dust bag/filter must be cleaned from
time to time to remove the fine dust
particles that have been collected.This can
be done by either shaking it or for a more
thorough clean, rinsing in cold water.
You may choose to rinse the dust cup
and/or dust bag/filter in cold water. Ensure
dust bag has dried before replacing it back
into the dust cup.
NOTE! Do not wash parts in the dishwasher. Use
only mild soap and avoid detergents, cleaners or
solvents that may damage the plastic.
Place the dust bag/filter carefully into the
dust cup.
Attach the dust cup back onto the Hand
Vacuum, by pressing the filter release
button and snapping the dust cup back
into place.
IMPORTANT: DO NOT USE
WITHOUT A DUST BAG IN PLACE
WARNING: DO NOT IMMERSE
THE HAND VAC OR CORD IN
WATER OR ANY OTHER LIQUID.
THE DUST BAG/FILTER IS THE
ONLY COMPONENT THAT CAN
BE RINSED CLEAN.