Kenwood KTC-SR901 - Manual (Page 6)

KTC-SR902/KTC-SR901 SIRIUS ® Satellite Tuner
Quick-Start Guide for:
KDC-X859/KDC-X759/KDC-MP919
Step 1: Get your unit’s individual
Electronic Serial Number (ESN):
a) Press the SRC button ( ) repeatedly until
“SIRIUS” appears on the display
b) Press the Play/Pause button ( )
c) Press the AM/FM buttons ( ) to scroll through
the options until “ESN XXXXXXXX” appears on
the display
d) Write the number down
e) Press the SRC button ( ) to exit
Step 2: Subscribe to the Sirius Satellite
Radio service
a) Make sure your vehicle has the radio "ON" and
the antenna has a clear view of the sky with no
obstructions (buildings, garage, etc.)
b) Have your Vehicle Identification Number (VIN)
from the vehicle that the radio is installed in.
c) Have your unit’s ESN and your credit card num-
ber handy
d) Contact SIRIUS on the web at siriusradio.com
or call toll-free: 1-888-539-SIRIUS (7474)
e) The operator will instruct you further
• Your tuner should be able to receive Sirius
Satellite Radio signals almost immediately after
you subscribe
Searching for program categories and
streams:
a) Press the SRC button ( ) until “SIR” appears
on the display
b) Hold-down the Preset 2/6 button ( ) until
“Category Name” appears on the display
c) Press the AM/FM buttons ( )to search
through the available program categories
d) Press the Scan Forward and Scan Backward
buttons ( ) to change channels within the
selected category
• If there are no streams available in a category,
the tuner will automatically switch to the next
category
Display settings setup:
a) Press the SRC button ( )until “SIR” appears
on the display
b) Press the preset 4/8 button ( ) to get into
the display setup mode.
c) Press the AM/FM buttons ( ) until “Display
Control Mode” appears on the display.
d) Hold-down either the Scan Forward or Scan
Backward button ( ) until “Channel Number”
appears on the display’s top line.
e) Use the AM/FM buttons ( ) to control the dis-
play’s top line.
f) Use the Scan Forward and Scan Backward but-
tons ( ) to control the display’s bottom line.
g) Press the preset 4/8 button ( ) again to exit
the display mode
Setting stream presets:
a) After tuning to the desired stream, press and
hold button 3/7 ( ) until “Preset Memory”
appears on the display
b) Use the AM/FM buttons ( ) to access the
desired preset number
c) Hold Preset button 3/7 ( )until the unit “beeps”.