Kenwood XD-351 - Manual (Page 15)

15
XD SERIES (En)
Operation
Muting the sound temporarily
(Remote control unit only)
÷ Press again to resume the original volume.
÷ The sound muting is also canceled when the volume is controlled.
Blinks
MUTE
kHz
MHz
ESET
AUSE ALL DISC RANDOM
MEMORY STOP
REPEAT 1 PRESET EQ AUTO
MORY
P.B.C
FLAT
AUTO
ROCK
PAL
POP
NTSC
JAZZ
STEREO TIMER SLEEP EX.BASS PROGRAM
L R
Listening through headphones
PHONES
Insert the headphone plug into the PHONES jack.
÷ The sounds from all speakers are cut off.
STANDBY mode of ON/STANDBY ( ) switch
When the power cable plug of this unit is inserted into a
receptacle, a minute current flows for memory
protection.This status is referred to as the STANDBY mode,
and the unit in the STANDBY mode can be turned ON from
the remote control unit.
For better visibility of the time display during
power OFF
SLEEP/
CLOCK LIGHT [Remote control]
When the SLEEP/CLOCK LIGHT key is pressed while the power is
OFF, the backlight lights for about 10 seconds.
Changing the Tone
Extra Bass
The factory setting is ON.
ROCK
FLAT
EX.BASS
POP
JAZZ
÷ Switching between ON and OFF
each time the key is pressed.
DOM
PRESET EQ O
B.C
FLAT
AUTO
ROCK
PAL
POP
NTSC
JAZZ
REO TIMER SLEEP EX.BASS
L R
Lit
Selecting the Desired Tone
ROCK
FLAT
EX.BASS
POP
JAZZ
EQ
Operation on the unit Remote control operation
÷ The sound of the pressed
key is selected.
÷ Press FLAT to cancel the
selection.
The sound is switched as
shown below each time
the key is pressed.
1 ROCK
2 POP
3 JAZZ
4 FLAT (cancelled)
M
PRESET EQ
C
FLAT
AUTO
ROCK
PAL
POP
NTSC
JAZZ
O TIMER SLEEP EX.BASS
L R
Simultaneous use with
EX.BASS is possible.
A frame is shown for the
selected sound.
Display Switching
When the power is ON, the display indication can be
switched.
DISPLAY
/DEMO
During CD Playback
Each time the DISPLAY/DEMO key (the DISPLAY key in case of
remote control) is pressed, the indication changes as shown below.
1 Number of the disc being played/title No./elapsed
time
2 Number of the disc being played/title No./remaining
time of the title
3 Number of the disc being played/title No./*remaining
time of the disc
4 Present time (return to 1 after several seconds)
*During REPEAT playback and RANDOM playback, the
remaining disc time is not displayed.
Other than During CD Playback
Each time the DISPLAY/DEMO key (the DISPLAY key in case of
remote control) is pressed, the indication changes as shown
below.
1 Normal display (TAPE/AUX/TUNER indication etc.)
2 Present time (return to 1 after several seconds)