Krell Industries RESOLUTION 1 - Manual (Page 20)

16
SECTION
FOUR
Connecting a Resolution Series Loudspeaker
to Your System
All Resolution loudspeakers are equipped with two sets of WBT binding posts.
The top set is connected to the midrange and/or tweeter drivers, and the bot-
tom set is connected to the bass drivers. To use banana-type loudspeaker ter-
minations, remove the plastic pins from the center of each loudspeaker connector.
Use a small pair of pliers to grasp the end of each pin and withdraw it from the
connector.
Each Resolution loudspeaker is shipped set up for standard operation, with a
jumper connecting the positive binding posts and a second jumper connecting
the negative binding posts. Follow these steps to connect a Resolution Series
loudspeaker to your system:
1. Make sure that all power sources and components are off before connecting
system components.
2. Locate the loudspeaker binding posts on the loudspeaker back panel.
3. Connect the loudspeaker cable from the positive binding post on the loud-
speaker to a positive channel output on the amplifier.
4. Connect the loudspeaker cable from the negative binding post on the loud-
speaker to a negative channel output on the amplifier.
Krell Resolution 1, 2, 3, and C Loudspeakers continued ᮣ